Process of how to reset DStv decoder without remote
First, unplug the power button from your decoder and ensure it is completely turned off. You can check for this by ensuring all its lights are turned off, and none is blinking. Turn it back on and press the reset button on your decoder.
How do I refresh my DStv decoder?
How to reset your DStv decoder
Press the blue “DStv button” on your remote control.Then use the right arrow on the remote control to go to “Settings“.Use the down arrow to go to “System Settings“.Now use the right arrow to go to the next menu and select “Reset Decoder Settings“
How do I hard reset my DStv?
Press the “Reset” and “Standby” buttons on the front panel of the decoder simultaneously. The letters “dL” will appear on your decoder display panel. Press and hold the TV/AUDIO button and the P+ button at the same time until “done” appears on the decoder display panel.
How do you reset a TV decoder?
How to manually reset your Dialog TV Decoder
Switch on your Dialog TV decoder.Press the menu button on your dialog TV Remote.Select “Installation” option (Option 2)Select “Factory Default” (option 3)Press “ok”Enter password – 0 0 0 0.System will now reset the Decoder (STB)
What causes decoder to stop working?
They usually occur when power restoration is accompanied by an oversupply of voltage. This damages the decoder’s power circuit. In some cases, it goes beyond the power circuit, damaging almost the entire circuit board of the decoder.
Can I reset my TV without remote?
Part 1: Manual Factory Data Reset with TV buttons
Press and hold the Power button and Volume Down (-) buttons on the TV (not the remote), and while holding the buttons, plug the power cord back in.
What must I do if my DStv remote is not working?
Press any button on the remote. If the green light does not blink (below INFO, BACK or both), the remote is either broken or needs new batteries. If you put in new batteries and the green light still does not blink when a button is pressed, you will need to replace the remote.
How do I reconnect my decoder?
decoder to your TV:
If you are using an HDMI cable, then plug it into the HDMI port on the back of your decoder and then plug the other end into an HDMI input port on your TV. You will then need to switch to the relevant HDMI source/input channel on your television.
Why is my DStv not getting signal?
The DStv signal not found error will most likely be caused by a faulty LNB cable. You can pinpoint the problem by switching the cables around and checking if the error persists. It could also be due to wear and tear on the cable. Check that the cable isn’t damaged anywhere, causing a short at the conductor.
How do I reconnect my DStv decoder?
Use DStv Self Service to do the reconnection.
USSD Code *120*68584#WhatsApp Nr.My Dstv.
How do you fix a DStv decoder when it says no signal?
Fix a DStv no signal error by following the steps below:
Step 1: Check your DStv connection cables. This is one of the easiest checks you can do on your own. Step 2: Reboot your decoder. Step 3: Inspect your DStv satellite dish. Step 4: Check your LNB. Step 5: Call the approved DStv installer.
How do I clear E48 32 error on DStv?
There is not much you can do to solve a no signal or searching for signal error (E48-32) when it is caused by rain. The best resolve is to have your dish aligned to optimize the DStv reception. Furthermore you could upgrade your DStv installation by installing a bigger dish.