How do you program a DStv remote control? Check it out | how to connect dstv remote to decoder

Programming steps

Step 1 Press and hold STANDBY and OPTIONS simultaneously for more than 3 seconds. The LED will give 2 short RED blinks to indicate the remote is now in programming mode. Step 2 Press 9 and then 8 then 1 The LED will blink RED once when you press 9 and 8 and twice RED once you have entered all digits.

Why is my decoder not responding to the remote?

You may also need to press the CABLE button at the top of the remote to direct the signal to the receiver and then try a few functions (Guide, Menu/Settings, etc.) to see if it is only certain buttons that do not work. Failing this, you can try resetting your receiver. Unplug your receiver and wait 15 seconds.

Why is my DStv remote not working?

Reset DStv remote

Hold down both the ARC and Standby for about 3 seconds. During this step, the remote lights should change to amber. Continue holding the ARC button as you release the Standby. While you are still pressing the ARC button, dial 9499.

Can any DStv remote work on any decoder?

One For All DSTV A7 Remote Control (Works With Explora 1 & 2) (URC-9250) The DSTV A7 Explora remote works with all DSTV HD & Explora decoders.

How do you reset a remote control?

For Android TVs released in 2015 or later, symptoms may improve by updating the software of the remote control.

Reset the remote control.
Open the battery compartment cover and remove the batteries.Press and hold the Power button for three seconds.Insert the batteries again and close the battery compartment cover.

Why is my DStv remote flashing red?

When using the remote : if there is one RED blink, the remote is already in “Standby Relay” or “Volume Relay” mode, but nothing has been programmed to that button, or there is in an error with the programming sequence.

Why is my remote not changing channels?

Television Remote Control Cannot Change The Channel

Check that the batteries in the remote control are not low or dead. If the batteries are low, the remote control may not change the channels on your TV.

How do I reset my DStv Explora A7 remote?

STEP 1: Press and hold Standby and Options buttons together until the LED blinks red twice. STEP 2: Press 9 for one red blink, then 8 for another red blink, then press 1 for 2 red blinks. STEP 3: Press OK for at least 3 seconds to get 4 red blinks, indicating that your A7 remote reset is complete.

How do I reset my DStv Explora A6 remote?

How to reset DStv A6 remote
Press and hold ARC and STANDBY buttons for 3 seconds.While holding the ARC button, release the STANDBY button.While holding the ARC button, press 9949.Finally, release the ARC button to complete the reset.

What is the standby button on DStv remote?

Quick tip: if you press and hold the STANDBY button, the DStv Explora will reboot. control other audio/visual equipment. Please see the Advanced A7 Remote Guide on dstv.com for detailed instructions. AV This remote can be programmed to control other audio/visual equipment.

How do I set my DStv remote to Mode 1?

To set the remote to mode 1: press and hold the i button for 3 seconds or until you see the green light blink on 1 (below the i button). If the green light blinks below BACK, the remote is in mode 2.

How do I use my phone as a DStv remote?

Open the Android PlayStore app. Enter a Dstv remote app name: “PVR remote” or “Remote for DSTV” Install app. Connect to the internet when opening the app for the first time.